Router configuration in cisco packet tracer
- Router configuration in cisco packet tracer how to#
- Router configuration in cisco packet tracer update#
Router configuration in cisco packet tracer how to#
If you stuck in configuring IP addresses, click here to know how to configure IP address or you can refer the following example.įor example, to configure TCP/IP addresses on Router1, execute the following commands: Router1(config)#interface fa0/1 We assume that you know how to configure IP addresses.
![router configuration in cisco packet tracer router configuration in cisco packet tracer](https://itexamanswers.net/wp-content/uploads/2017/03/2017-04-06_001532.png)
If you are using a simulator, such as Cisco Packet Tracer or GNS3, create the preceding topology and configure the devices as per the values mentioned in the following table.įirst of all, configure the IP addresses on each device. If you are using a simulator, such as Cisco Packet Tracer or GNS3, create the following topology and configure the IP addresses as mentioned in the topology. To demonstrate how to configure RIP in Cisco Packet Tracer, we will use the following network topology. The following table lists the various types of timers used by the RIP protocol to optimize the network performance. Routing protocols use timers to optimize the network performance.
![router configuration in cisco packet tracer router configuration in cisco packet tracer](https://static.cdn.asset.aparat.com/avt/6657267-2756-b__458094142.jpg)
Router configuration in cisco packet tracer update#
![router configuration in cisco packet tracer router configuration in cisco packet tracer](https://benisnous.com/wp-content/uploads/2021/06/static-routing-with-Connecting-4-routers-with-explanation-Cisco-800x445.jpg)
It uses hops count metric to calculate the best path from a source to a destination network.Some of the of key features of RIP protocol are: Typically, it is suitable for a small-sized network. Since it is an IGP protocol, it can only be used to perform routing between networks within the same autonomous system. RIP protocol is an open standard, distance-vector, Interior Gateway Routing (IGP) routing protocol. In this post, we will discuss some of the key features of Routing Information Protocol (RIP) and the step by step guide to configure RIP on Cisco routers using Cisco Packet Tracer. In the previous post, we have discussed the basics of routing and how to configure static routing.